Deck and Porch Construction in Apex, NC
Licensed and insured, about 25 minutes from our base, with a fixed written price before any work starts.
The screened porch roof leaks where it meets the house, or the deck boards feel spongy or bounce when you walk across them. Those are the calls we take most often from Apex homeowners, and neither one improves on its own.
RK Renovation handles deck and porch construction across Apex and the rest of Wake County. New decks, structural rebuilds and screened porches, permitted through your county inspections office and framed to outlast the boards on top.
What the price covers
- Demolition and haul away. Old decking, rail and any framing that does not meet current load requirements comes off and out to the dumpster, so we are never building a new deck on top of a compromised one.
- Footings and framing. Concrete footings dug below the frost line and sized to the actual load, pressure treated framing lumber, joist hangers and structural screws rated for exterior use rather than deck screws doing a job they were never rated for.
- Ledger attachment and flashing. Through bolted to the house rim joist, never just nailed, with flashing that sheds water away from the band board instead of trapping it behind the siding.
Deck and Porch Construction in Apex, in practice
Piedmont clay is the soil under most decks we build in Apex, and it behaves nothing like sand or loam. It expands when it is wet and shrinks when it dries, which can lift or tilt a footing that was poured too shallow or without enough bearing area. Code in Wake County generally calls for footings that reach undisturbed soil below the frost line, and we size the diameter to the actual tributary load of each post rather than pouring one standard tube for every location. On a sloped lot, one corner sometimes sits on a footing twice the depth of the others. Getting this step right is what keeps a deck from developing a slow lean five years after the last board is nailed down.
The ledger board is the single point where a deck attaches to the house, and it fails more often than every other part of the frame combined. We through bolt the ledger to the rim joist of the house in Apex, never relying on nails alone, and we flash it with a metal flashing that tucks under the house wrap or siding and sheds water forward over the ledger rather than behind it. Skip that flashing and every heavy rain in Wake County drives water down the band board and into the floor framing, where it rots quietly until someone notices a soft spot or the deck starts to pull away from the wall. It is a small detail that decides whether the connection lasts thirty years or five.
Free Estimate
Apex homeowners: tell us about the project and we will put a number in writing.
What Apex homes need
Two housing worlds in one town. The Salem Street blocks hold turn of the century homes with real character and real quirks, while everything east of Highway 55 is a 1998 to 2015 subdivision with tall ceilings and hollow core doors.
Permits for structural, plumbing and electrical changes go through the Town of Apex Building Inspections. We file them, schedule the inspections and meet the inspector, so the work is on the record when you eventually sell.
We work across Historic Downtown Apex, Scotts Mill, Haddon Hall, Bella Casa and the rest of Apex, and we are about 25 minutes from our base.
Everything we do in Apex
How a Apex project runs
Four stages, each finished before the next begins. Typical duration is 2 to 6 weeks.
Site visit and layout
We walk the yard, check the slope and drainage, look at what is under the house where the ledger will attach, and lay out the footprint against how you actually want to use the space.
Design and permit
Footing size, beam and joist spans and guard height get drawn up and filed with the local inspections office before any lumber is ordered.
Footings, framing and ledger
Footings poured, posts and beams set, joists hung, and the ledger through bolted and flashed to the house, then the framing inspection called before decking goes down.
Decking, rail, stairs and finish
Decking installed, rail set to code height, stair stringers cut to a consistent rise and run, then stain or sealer applied and a final walk through with you.
Questions from Apex homeowners
Do you pull the deck permit in Apex?
Yes. We file the plan with the Apex inspections office, schedule the framing inspection before decking goes down, and meet the inspector ourselves so you are not stuck waiting around for someone else to show up.
How quickly can you start a deck in Apex?
We typically estimate within a few days and start within three to five weeks, once the permit is filed and material is ordered. Composite decking and rail systems often carry a longer lead time in Wake County than our own schedule does.
Do you handle HOA approval for a deck in Apex?
Many neighborhoods in Apex run an architectural review for exterior changes including decks and porches, and we build the submission package, materials list and elevation sketch so you are not the one chasing down committee requirements yourself.
What is the difference between composite and pressure treated decking?
Pressure treated pine costs less and needs a fresh coat of sealer every couple of years to hold up through Carolina summers. Composite costs more up front, will not splinter or need staining, and generally outlasts pressure treated by a wide margin.
What it usually costs
Deck and Porch Construction in Apex generally runs between $8,500 and $52,000, depending on size and finish level. The estimate is free and the number we write down is the number you pay.
Call (919) 335-7730What homeowners say
Pulled straight from our Google Business Profile, and updated as new reviews come in.
Keep looking
The same trade in nearby towns, and the rest of what we do in Apex.
Deck and Porch Construction nearby
Other work in Apex
Deck and Porch Construction in Apex
Free estimates across Apex and the wider Triangle, with a fixed written price before any work starts.