Drywall Installation and Repair in Garner, NC
Licensed and insured, about 15 minutes from our base, with a fixed written price before any work starts.
Garner holds a lot of 1960s to 1980s brick ranches, which are some of the best value renovations in Wake County. Solid framing, generous lots, and interiors built around small closed rooms that open up beautifully once the right wall comes out.
That is the ground every drywall installation and repair project in Garner starts from. Patches that disappear under paint, ceiling repairs, full room hangs and Level 5 finishes for walls that catch raking light.
What the price covers
- Framing and structural check. Joists, studs and truss chords behind the damage get checked for rot or movement before anything new goes up, so the patch is not screwed to something already failing.
- Hanging and taping. New board hung with the right screw pattern and spacing, joints taped in paper or mesh, and coated in the number of mud coats the finish level actually calls for.
- Texture matching. Orange peel, knockdown or smooth walls get matched to the existing texture with the same tools and technique, so the patch reads as part of the wall rather than a rectangle on top of it.
Drywall Installation and Repair in Garner, in practice
Drywall finish has six defined levels, and most homeowners have never heard the term even though they live with the results every day. Level 0 is unfinished board for a wall that will be covered later. Level 4 is standard for most rooms in a Garner house: taped joints with three coats of mud and a light sand, fine under normal paint and light. Level 5 adds a full skim coat of mud over the entire surface, not just the joints, which kills the flashing you get when a flatter sheen paint sits over an untreated seam. It matters most on a wall lit edge on by a window, or anywhere in Wake County using low sheen paints that show every imperfection in the board underneath.
Every drywall repair fails the same way when it is rushed: the patch gets mudded and sanded smooth, then painted, on a wall that was never smooth to begin with. Orange peel, knockdown and hand troweled finishes all reflect light differently than a bare skim coat, so a smooth patch reads as a shadow the moment the sun crosses the room. We match texture with the same hopper gun or knockdown knife technique the original installer likely used, tested on scrap first. Screw pops are a related, separate problem, common in Garner framing as seasonal humidity swings move the trusses a fraction of an inch. Resetting the fastener and bridging the crack with a flexible compound stops it from reopening next dry season.
Free Estimate
Garner homeowners: tell us about the project and we will put a number in writing.
What Garner homes need
Garner holds a lot of 1960s to 1980s brick ranches, which are some of the best value renovations in Wake County. Solid framing, generous lots, and interiors built around small closed rooms that open up beautifully once the right wall comes out.
Permits for structural, plumbing and electrical changes go through the Town of Garner Inspections Department. We file them, schedule the inspections and meet the inspector, so the work is on the record when you eventually sell.
We work across Vandora Springs, Heather Hills, Forest Ridge, Adams Point and the rest of Garner, and we are about 15 minutes from our base.
Everything we do in Garner
How a Garner project runs
Four stages, each finished before the next begins. Typical duration is 1 day to 1 week.
Assess and scope
We check whether the damage is cosmetic, moisture related or a sign of structural movement, and whether the wall needs a patch, a full sheet, or a full room hang.
Cut back and hang
Damaged material comes out to a clean edge, new board goes up screwed into framing on the standard pattern, and any wet framing behind it gets addressed first.
Tape, mud and match texture
Joints get taped and coated to the finish level the wall needs, then the surrounding texture gets matched before anything is sanded smooth.
Sand, prime and inspect
Final sanding under a raking light catches what daylight would otherwise catch after you move back in, then primer goes on and we walk the repair with you.
Questions from Garner homeowners
Do you match texture on older plaster walls in Garner?
Older sections of Garner still have real plaster over lath rather than drywall. We can patch small areas in plaster or convert a damaged section to drywall and blend the texture, depending on the extent of the damage.
How fast can you get to a ceiling leak repair in Garner?
Active leaks get priority scheduling. We can usually assess a Garner ceiling within a day or two of your call, confirm the source with you, and hold the drywall repair until the area has dried to a safe level.
Do you handle drywall after a wall removal in Garner?
Yes. When we open a wall in Wake County for a layout change, the same crew patches the ceiling and flanking walls, matches texture on both sides, and leaves the room paint ready.
Will the patch be visible after it is painted?
Not if the texture and sheen are matched correctly. A patch that is only sanded smooth on a textured wall will show under any angled light. We match the surrounding texture as a standard part of the repair, not an upgrade.
What it usually costs
Drywall Installation and Repair in Garner generally runs between $450 and $9,500, depending on size and finish level. The estimate is free and the number we write down is the number you pay.
Call (919) 335-7730What homeowners say
Pulled straight from our Google Business Profile, and updated as new reviews come in.
Keep looking
The same trade in nearby towns, and the rest of what we do in Garner.
Drywall Installation and Repair nearby
Other work in Garner
Drywall Installation and Repair in Garner
Free estimates across Garner and the wider Triangle, with a fixed written price before any work starts.